Evenflo Snugli Manual Del Usuario página 4

ASSEMBLING YOUR STROLLER
5
F F o o r r w w a a r r d d F F a a c c i i n n g g
K
L
M
N
K
To remove the seat assembly , pull both locking levers
upward while lifting the seat assembly from the stroller
frame.
4
K
To Install the seat assembly in either forward-facing or
L
rear-facing position, place the seat sockets
M
mounting heads . Make sure the seat sockets lock onto
the mounting heads with audible clicks.
Pull upward on the seat assembly to make sure it's locked
securely onto the stroller frame.
R R e e a a r r F F a a c c i i n n g g
K
L
M
N
6
P
over the
1
B
2
F
D
C
O
When installing the canopy
positioned behind the seat back
Attach the canopy clips
Q
R
R
Avoid serious injury from falling or sliding out.
To open the bumper bar
A
side of the stroller, and swing the bar outward.
F
Avoid serious injury from falling or sliding out.
Place the baby in the seat and bring the crotch panel
between the child's legs. Fasten each buckle
E
to adjust the waist and shoulder restraints (shoulder restraints only
for 5 point) for a snug, comfortable fit.
Note: To loosen straps, push in the release button
and pull up.
Once the child is properly restrained, close and lock the bumper bar.
To change from 5-point to 3-point harness:
Remove each harness strap
F as shown. Remove both harness straps from strolle
seat back. Store shoulder harness straps for future
use.
D
ASSEMBLING YOUR STROLLE
O P
, make sure the back flap is
Q
.
R
to the seat assembly tubes.
Make sure each canopy
R
clip is placed over each
S
S
locating post .
R
USING YOUR STROLLE
WARNING
ALWAYS use waist restraint.
A B
, press the locking button , on eithe
WARNING
ALWAYS use waist restraint.
C
up
D
and pull the straps
E
on the buckle
F D
from each buckle