Cleaning And Maintenance; Filter Installation - Schwarzwald-Lab AP1207 Manual De Instrucciones

SET UP & USE

CLEANING AND MAINTENANCE

WARNING: Be sure to unplug from the electrical supply source before cleaning or changing
the filter.
Do not use liquids to clean the air purifier.
Do not attempt to disassemble the air purifier for cleaning.
•
Wipe the exterior of the air purifier with a soft, dry cloth. Make sure the particle
sensor does not become clogged with dust.
•
If necessary, wipe only the exterior housing with a damp cloth, then immediately dry.
•
You can vacuum the inside of the air purifier.

FILTER INSTALLATION

Your air purifier comes with a 3-stage (Pre-filter + HEPA+ Activated Carbon) Filter. To
access the filter, turn the bottom filter cover by the handle counterclockwise (towards the
unlock symbol) to remove it. Lift the filter out of the air purifier. Remove the plastic bag and
reinstall the filter.
Replace the filter cover by turning it clockwise (towards the lock symbol) until it locks
The REPLACE FILTER
need to replace the filter sooner if you are using the air purifier in an environment with poor
air quality. If you notice that he filter does not appear visibly clean, or air purification seems
to have decreased the filter should be replaced.
Use Replacement Filter Model AF1. To purchase a replacement filter, it is recommended
that you check with the retailer where you purchased your air purifier, or major online
retailers. You can also contact the Schwarzwald Customer Satisfaction Center at
www.schwarzwald-appliances.com
NOTE: After replacing the filter, press the REPLACE FILTER indicator light for 3 seconds
until the control panel lights illuminate and the unit does not make any make a
beeping sound in order to reset it.
STORAGE
If you are not going to use the air purifier for a long time make sure it is clean and dry. Wrap
the filter in plastic. Store in a cool dry place.
01 indicator light will illuminate after 2,000 hours of use. You may
REPLACEMENT FILTER