Operating Controls; Start-Up; Operating Times; Assembly - MTD products Cub Cadet 769-12285 Manual Del Usuario

Operating controls

operating controls
operating elements (Fig . P )
1 Power pack release
2 Handle
3 Hook for carrying belt
4 Middle handle
5 Height adjustable telescopic arm
6 Adjustment of edge cutting function
7 Protective cover
8 Plant protection bow
9 Shield lock
10 On/off switch
11 Unlock (both sides)
12 End stop height adjustment / middle handle adjustment
13 Working angle adjustment
14 Shield
15 Power pack compartment
16 Carrying belt
17 Wheels bracket
18 Adapter
19 Wheels
20 Spool cap for plastic knife
21 Plastic knife
22 Line box
23 Line spool
24 Spool cap
25 Cutting device for shortening the line length
Information
Operating elements marked with
optionally available as accessories and not
contained in the scope of the delivery.

Start-up

Supplementary documentation
Make sure the operating instructions of
the PoWEr cHArGEr 80V LI-IoN char-
ger and of the PoWEr PAcK 80V LI-IoN
power pack are available . Please read
and understand them before putting the
device into use .
Power pack charging
Risk of injuries or material damage
¾ Only charge the power pack with the
POWER CHARGER 80V lithium-ion
charger.
769-12285
All manuals and user guides at all-guides.com
are
WArNING!
Attention!
The power pack is supplied partially charged. Be-
fore first use, fully charge the power pack using the
POWER CHARGER 80V Li-ion charger to ensure
the full capacity of the power pack.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.

operating times

Observe the times stipulated in local byelaws.
Î
Check if there are any operating time limitations
Î
with your local authorities.

Assembly

Fitting the protective cover (Fig . B )
Forcefully press the protective cover Ac on to the
Î
trimmer B 1 .
3 The protective cover audibly engages.
Attaching the shield (Fig . C )
Note
The shield must be removed before using
the edge cutting function.
The shield Ab prevents the cut material from being
excessively scattered if you are working close to the
edge of the lawn area.
Clip the shield into the protective cover C 1 .
Î
Fold the shield lock over the shield to provide
Î
additional securing C 2 .
Attaching the carrying belt (Fig . D )
Attach the carrying belt Af at the two hooks D .
Î
Note
For safety reasons only carry the device
supported over your shoulder and never
around your neck. The belt has a quick
release attachment so that it can be quickly
disconnected in the event of a malfunction.
EN
21