Product Maintenance - Fellowes POWERSHRED 90S Guia De Inicio Rapido

BASIC SHREDDING OPERATION
PAPER OR CD/CARD
1
1
Continuous operation:
NOTE: Shredder runs briefly
after each pass to clear entry.
Plug in and put
Continuous operation beyond
disconnect power
switch in ON (I) position

PRODUCT MAINTENANCE

CLEANING AUTO-START INFRARED SENSORS
no paper present.
TO CLEAN THE SENSORS
2
1
shredder
infared sensor
TROUBLESHOOTING
A B
LIMITED PRODUCT WARRANTY
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be
repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by
2
2
Feed paper straight into
Press ( ) ON to
paper entry and release
activate (blue)
.
3 4
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
C D
3
4
or
cards rotate safety flap
into place
A. Overheat Indicator:
not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
B. Bin Open:
C. Bin Full:
D. Remove Paper:
Fellowes to provide parts or services outside of the country where the shredder is initially sold
5 6
When finished
Feed into center of shredding set
entry and release to OFF ( )
) and remove paper.
3