EUROM EK3301 Instrucciones De Uso página 15

Technical data
Type
Supply voltage
Maximum capacity
Settings
Insulation class
Dimensions
Weight
General safety instructions
1. Before using the machine, carefully read this entire
instruction manual.
2. Before using your new heater, check it, including cord and
plug, for any visible damage. Do not use a damaged heater,
but send it back to your dealer for replacement.
3. This heater is exclusively intended to heat workspaces such
as workshops, garages and storage spaces. Use the
appliance for this purpose only.
4. Under the terms and conditions described in this leaflet, the
heater can be used in wet or damp indoor spaces such as
bathrooms and laundry rooms. Do not place the heater in
the vicinity of taps, bathtub, shower, pool, fountains or other
sources of moisture. Make sure it cannot fall into water and
prevent water from getting into the heater itself. If, at any
time, the heater does fall into water, unplug it immediately!
Do not use a heater that has a damp interior but have it
repaired. Never immerse the heater, cord or plug in water
and never touch it with wet hands.
5. The supply voltage and utility frequency, specified on the
machine, need to match those of the socket that is used.
The electrical installation needs to be protected by a
residual current device (max. 30 mAmp).
6. Fully extend the cord before plugging in the heater. Make
sure it does not come into contact with any part of the
heater and prevent it from heating up any other way. Do not
run the cord underneath carpeting; do not cover it with
mats, carpet strips or similar and make sure it is not placed
in any passageways. Make sure the cord cannot be stepped
English
EK3301
Volt/Hz 230 / 50
Watt 3000
Watt 0-fan-1500-3000
IP24
cm 35,5 x 30 x 46
kg 6,0 kg
15