DHG SystemRoMedic EasyGlide Manual De Usuario página 4

Placement/removal of EasyGlide
Using EasyGlide
Active users can transfer themselves with the help of EasyGlide. Grasp the armrest and lean over
towards the wheelchair. It is important to remember to lean once more towards the bed when
the transfer is complete, so as to be able to move back in the middle of the chair and slide all the
way back.
If the client requires support and assistance during the transfer, the EasyGlide should be
complemented with an EasyBelt/FlexiBelt.
The caregiver can work from behind or in front of the client.
Tips! Our FootStool can be used to advantage to raise the knees
EasyGlide can also be used for transfers into and out of a car.
Material
Polyethen
Care of the product
The surface of the product can be cleaned with warm
water or a soap solution. If disinfection is needed, 70 %
ethanol, 45 % isopropanol or similar should be used.
4
Place the wheelchair at an angle towards the side of the bed, and as close
to the bed as possible. Remove the armrest that is closest to the bed and
remove leg supports. Place the EasyGlide like a bridge between the bed
and the wheelchair. If it is an EasyGlide model on which one long side can
be bent, this should be placed against the wheelchair wheel.
To position the EasyGlide under the client, lean the client slightly in the
opposite direction.
When the transfer is complete, EasyGlide is removed by bending upwards.
Contact your local distributor if you have any questions
about the product and its use.
See www.directhealthcaregroup.com for a complete list of
distributors.
Expected lifetime
Up to 10 years of normal use.
System
I F U