Use And Maintenance - DeLonghi КС-RT60 B Manual De Utilización

• FIXING TO THE WALL
Drill the holes A respecting the distances indicated (Fig.2).
Fix the appliance to the wall and align it in horizontal
position to the wall units. Once the adjustment has been
completed, fix the hood in place using the screws A and
B (Fig. 4).
• FIXING THE DECORATIVE DUCTING IN PLACE
Arrange the electrical power supply within the dimen-
sions of the decorative flue. If your appliance is to be
installed in the ducting version or in the version with
external motor, prepare the air exhaust opening. Adjust
the width of the ducting support bracket C (Fig. 3).
Connect flange D to the air exhaust hole using a flexible
hose (Fig. 5). Place the ducting inside the bodywork and
move it upwards or downwards in order to adjust it to the
desired height (Fig. 3). Fix the bracket to the wall, on an
axis with your cooker hood, using screws A (Fig. 3) and
respecting the measurements indicated (Fig. 2). Fix the
sides of the ducting to the bracket, using screws B (Fig.
3).
• FIXING THE CORNER FITTED COOKER HOOD TO THE
WALL
Once the overall dimensions of the cooker hood have
been checked, the company recommends you ask two
people to help when fixing it to the wall.
Prepare the corner fitted cooker hood and adjust it to the
desired height (Fig. 7).
Use a pencil to mark the holes at the side, which will be
used to fix the appliance to the walls (Fig. 6). Make the
holes and fix the cooker hood to the wall using screws A
(Fig. 8). Fix it securely using the safety screws B (Fig. 6).
Connect flange D to the air exhaust hole using a flexible
hose (Fig. 7).
To transform the hood from a ducting version into a
filtering version, ask your dealer for the charcoal filters
and follow the installation instructions.

USE AND MAINTENANCE

• It is recommended to operate the appliance prior to
cooking.
It is recommended to leave the appliance in operation for
15 minutes after cooking is terminated in order to com-
pletely eliminate cooking vapours and odours.
The proper function of the cooker hood is conditioned by
the regularity of the maintenance operations, in particu-
lar, the active carbon filter.
• The anti-grease filters capture the grease particles
suspended in the air, and are therefore subject to clog-
ging according to the frequency of the use of the appli-
ance.
In order to prevent fire hazard, it is recommendable to
clean the filter at a maximum of 2 months by carrying out
the following instructions:
- Remove the filters from the cooker hood and wash them
in a solution of water and neutral liquid detergent, leaving
to soak.
- Rinse thoroughly with warm water and leave to dry.
- The filters may also be washed in the dishwasher.
The aluminium panels may alter in colour after several
washes. This is not cause for customer complaint nor
replacement of panels.
• The active carbon filters purify the air that is replaced
in the environment. The filters are not washable nor re-
useable and must be replaced at maximum every four
months. The saturation of the active carbon filter de-
pends on the frequency of use of the appliance, by the
type of cooking and the regularity of cleaning the anti-
grease filters.
• Clean the fan and other surfaces of the cooker hood
regularly using a cloth moistened with denatured alcohol
or non abrasive liquid detergent.
• The illumination installation is designed for use during
cooking and not for prolonged general illumination of the
environment. Prolonged use of the illumination installa-
tion notably reduces the duration of the bulb.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY
FOR EVENTUAL DAMAGES CAUSED BY BREACHING
THE ABOVE WARNINGS.
- 14 -