Reverse Run; Cleaning; After-Sales Service; Disposal - Graef FW 500 Manual De Instrucciones

• After finishing the mincing process, press the Start / Stop button.
• In order to disassemble the unit, pull the plug out of the socket, push the lo-
cking lever upward, remove the attachment and disassemble all individual
parts in reverse sequence.

Reverse run

If the unit blocks, press "REV". The screw rotates into the opposite direction.

Cleaning

Clean the unit with a soft moist cloth, and let to dry subsequently. Do not flush
the unit in water and do not immerse it in water.
All accessory parts can be cleaned in warm water using washing-up liquid.
NOTE
• The unit and all accessory parts are not dishwasher-safe.
• Pull the mains plug before each cleaning process.
Let all parts dry completely after cleaning. Reassembly the mincing machine
attachment again.

After-sales service

If your unit is defective, please contact your specialist dealer or the Graef custo-
mer service on +49 2932-9703677 or write an e-mail to service@graef.de

Disposal

At the end of its service life, this product cannot be disposed of in
normal domestic waste, but has to be taken a collection point ensu-
ring the recycling of electronic household waste. The symbol on the
product and in the operating instructions point out to this fact. Reuse
the materials according to their marking. With the reuse, recycling or other
forms of recycling of old equipment, you make an important contribution to the
protection of our environment. Please ask your municipal administration for the
disposal point.

Two-year warranty

For this product, we assume 24 months manufacturer warranty for defects,
which are due to production or material defects. Your legal warranty claim
in conformity with Section 439 et seq. of the German Civil Code (BGB) shall
remain unaffected by this regulation. The guarantee does not cover any dama-
32