Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8
Operation
NOTICE
Dirt can damage the valve! Before connecting, check the
tire chuck (B) and the valve for dust and other foreign particles. Clean both
if necessary.
NOTICE
To inflate an item, it is not necessary to switch the product on.
•
Connect the tire chuck (B) to the tire valve. The display (D) shows the
tire pressure.
•
Press the inflation lever (I) to increase the pressure.
•
To decrease the pressure, press the deflation button (G).
•
When the desired pressure is reached, remove the tire chuck (B) from
the valve: Press the lever of the tire chuck (B) and remove it.
Cleaning and Maintenance
NOTICE
During cleaning, do not immerse the product in water or
other liquids. Never hold the product under running water.
Cleaning
•
To clean the product, wipe with a soft, slightly moist cloth.
•
Dry the product after cleaning.
•
Never use corrosive detergents, wire brushes, abrasive scourers,
metal or sharp utensils to clean the product.
Inlet filter
•
Regularly ensure that the supported air is clean, without any of oil, dirt
or moisture. Refer to the instruction manual of the compressor or the
preconnected filter.
Storage
•
Store the product in its original packaging in a dry area. Keep away
from children and pets.
Maintenance
•
Any other servicing than mentioned in this manual should be
performed by an authorized service representative.
Felt filter of deflation button
NOTICE
We recommend to change the felt filter every 6 months.
•
Use a suitable hexagonal wrench to screw off the deflation button (G).
•
Replace the inner felt filter (M).
•
Screw in and tighten the deflation button (G) and tighten it.
Publicidad
Tabla de contenido
