Hilti NURON SR 4-22 Manual De Instrucciones Original página 15

Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The battery runs down more
quickly than usual.
The battery does not engage
with an audible click.
The LEDs do not light up.
The saw blade cannot be
removed from the chuck.
Product does not develop full
power.
The saw blade cannot be
removed from the chuck.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
*2243481*
Possible cause
Battery condition is not optimal.
The retaining lugs on the battery
are dirty.
The battery is not fully inserted.
Battery defective.
The locking lever was not pushed
as far as it will go.
Blade holder clogged by residues
from sawing operations.
The control switch is not fully
pressed.
The battery is discharged.
The locking sleeve is not turned as
far as it will go.
2243481
Action to be taken
▶ Call up the battery's state of
health. → page 6
▶ Clean the retaining lug and refit
the battery.
▶ Push the battery in until it
engages with an audible click.
▶ Contact Hilti Service.
▶ Turn the locking lever as far as
it will go and remove the saw
blade.
▶ Remove the residues from
sawing operations and regularly
clean the blade holder from the
outside. Care of the product.
→ page 10
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
▶ Turn the locking sleeve as far as
it will go and remove the saw
blade.
English 11