6.
Place the glass jug (3) on the base
(6) and turn it clockwise.
7.
Fill the ingredients into the jug.
CAUTION!
8.
Do not exceed the maximum quantity
of 1.5 litres.
9.
Press the lid (2) firmly on the jug.
10. Place the measuring cup (1) into
the opening and turn it clockwise.
OPERATION
1.
Switch the appliance on:
LOW/NIEDRIG:
for liquid ingredients
HIGH/HOCH
for solid ingredients
for mixing of solid and liquid
ingredients
P = quick break switch
for crushing of ice
for rapid powerful mixing
2.
The quick break switch does not
click it, but has to be held during
operation. As soon as it is released
the motor stops. Only use it in
short intervals of 5 to 10 seconds.
3.
After use switch to OFF position
and take the plug out of the
socket.
4.
To unlock turn the jug assembly
counterclockwise and take it off.
5.
In general all ingredients are
given into the jug at one time.
6.
In case of large quantities, mix in
several steps one by one.
7.
Solid ingredients such as cheese
or vegetables should be cut into
pieces before adding it.
8.
If not provided otherwise in
the recipe, add first the liquid
ingredients and then the solid
22
Copyright UNOLD AG | www.unold.de
Insert the jug
11. Make sure that the switch is in
OFF position.
12. Place the properly assembled jug
on the motor block (7) and turn it
clockwise until it locks into place.
ingredients. Due to the liquid
the food can be processed more
rapidly and on a lower speed.
9.
We recommend to blend in short
intervals of 5–30 seconds, and
then to check the consistency of
the processed food.
10. Do not run the mixer for a
long time without interruption
(max.
5 minutes).
appliance has to cool down for
5–10 minutes.
11. Only use the blender with the
lid in place. Hold the lid firmly
pressed down with your hand
during operation.
12. Additional
ingredients can be added through
the opening in the lid. Please be
careful: the content may splash
out.
13. Be
extremely
processing hot ingredients.
14. When processing solid ingredients
we recommend to the use the
quick break switch several times.
This avoids the knife from getting
blocked.
15. Do not take off the jug assembly
before the motor has completely
stopped.
When
Then
liquids
and
other
careful
when
adding
warm
the