Electrical - Craftsman 138.37097 Manuel Del Operador

DOUBLE INSULATION
See Figure 2.
Double insulation is a concept in safety in electric
power tools, which eliminates the need for the usual
threewire grounded power cord. All exposed metal
parts are isolated from the internal metal motor
components with protecting insulation. Double
insulated tools do not need to be grounded.
WARNING!
READ AND UNDERSTAND ALL
INSTRUCTIONS. Failure to follow all instructions listed
below and on the machine may result in electric shock,
fire, and/or serious personal injury.
NOTE: Servicing of a product with double insulation
requires extreme care and knowledge of the system
and should be performed only by a qualified service
technician. Always use original replacement parts as
listed in the Parts List pages of this manual.
ELECTRICAL CONNECTION
This product has a precision-built electric motor. It
should be connected to a power supply that is 120
volts, 60 Hz, AC only (normal household current).
Do not operate this product on direct current (DC).
A substantial voltage drop will cause a loss of power
and the motor will overheat. If the product does not
operate when plugged into an outlet, double-check
the power supply.
EXTENSION CORDS
See Figure 2.
When using a power tool at a considerable distance
from a power source, be sure to use an extension
cord that has the capacity to handle the current the
product will draw. An undersized cord will cause a
drop in line voltage, resulting in overheating and loss
of power. Use the chart to determine the minimum
wire size required in an extension cord. Only round
jacketed cords listed by Underwriter's Laboratories
(UL) should be used.
When working outdoors with a product, use an
extension cord that is designed for outside use. This
type of cord is designated with "WA" on the cord's
jacket.
Before using any extension cord, inspect it for loose
or exposed wires and cut or worn insulation.
All manuals and user guides at all-guides.com

ELECTRICAL

8 — English
It is possible to tie the extension cord and power
cord in a knot to prevent them from becoming
disconnected during use. Make the knot as shown in
figure 2, then connect the plug end of the power cord
into the receptacle end of the extension cord. This
method can also be used to tie two extension cords
together.
WARNING!
Keep the extension cord clear of
the working area. Position the cord so that it will not
get caught on lumber, tools, or other obstructions while
you are working with a power tool. Failure to do so can
result in serious personal injury.
WARNING!
Check extension cords before
each use. If damaged replace immediately. Never use
the product with a damaged cord since touching the
damaged area could cause electrical shock resulting in
serious injury.
PROPOSITION 65
WARNING!
Some dust created by power
sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• lead from lead-based paints
• crystalline silica from bricks and cement and
other masonry products
• arsenic and chromium from chemically-treated
lumber
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a
well ventilated area, and work with approved
safety equipment, such as those dust masks that
are specially designed to filter out microscopic
particles.