Turning The Power On And Off - Fujitsu Ten ECLIPSE CD2000 Manual Del Propietário

Turning the power on and off

When the power is turned ON, the last source
mode (such as CD and tuner) used prior to
turning OFF the power will be restored.
When the vehicle has no ACC position on the
ignition switch, care is needed when turning off
the equipment. Follow Step 2 or Step 3 when
turning off the power.
When power is OFF, press the
1
[PWR] button.
The power will come ON.
ATTENTION
When the equipment's power is turned on
for the first time or if the battery terminals
have been disconnected
vehicle maintenance and the power is then
turned back on, the equipment will start up
in FM1 mode. After this, the broadcast
stations will be searched for automatically
and stored in buttons [1] to [6].
When power is ON, press the
2
[PWR] button for less than two
seconds.
The power will go OFF and the
equipment will be in Standby.
If you press the [PWR] button again for
more than one second, the power will
go completely off.
When power is ON, press the
3
[PWR] button for more than two
seconds.
The power will go completely OFF.
ATTENTION
If a car is not equipped with an ACC position,
press the [PWR] button for more than two
seconds.
All manuals and user guides at all-guides.com
because of
Names of controls and parts
III
11