Logic3 PSU448 Manual De Instrucciones página 7

Force Connect – PSU449 only
Use the Force Connect button to manually connect a steering wheel to its respective receiver.
1. Connect the receiver to your PS2 controller port or PS3 / PC USB port
2. Press the button "Select + down" on the steering wheel.
3. Press the FC Button on the receiver
TROUBLE SHOOTING
The Steering Wheel does not locate in the neutral centre,
Do not turn the Wheel when you are switching on your PlayStation . If the Wheel is not at its neutral (centre)
position when the console is turned on, then the position that it is held at will be read as the new neutral
(centre) position, and this may cause the unit to operate incorrectly. To reset to the neutral position, switch off
the console, leave the Wheel centralized, and then turn on the console again.
The controller does not function properly:
Please check to ensure that the button/pedal not working has not been relocated – Please follow the
instructions in the Relocation section. Please follow the instructions to clear a button remap.
PlayStation
Check the control mode switch, the "Analog Button". If the game does not support the mode that you have set,
then the controller (TOPDRIVE wheel) may not operate correctly. Try to select another mode to suit the game
& reset your console.
The Pedals do not seem to work,
Please check to ensure that the button/pedal not working has not been relocated – Please follow the
instructions in the Relocation section. Please follow the instructions to clear a button remap.
Please make sure the game you are playing is set up so that the acceleration and brake are using the
following functions. (PlayStation - Acceleration "X" button, brake " " button . Please refer to the software
manual on how to change the acceleration and brake settings.
The gearshift does not work,
Please check to ensure that the gearshift function has not been relocated – Please follow the instructions in
the Relocation section. Please follow the instructions to clear a button remap.
Please make sure that the game is set to Manual Gear Selection (MT) mode. If the game is in Automatic Gear
Selection mode (AT), then the game will change gear for you automatically, making the Topdrive gearshift
redundant.
Conformity
Herewith Logic3 plc declares that the device TopDrive Freebird RF Wheels & Pedals, conforms with the
relevant requirements and standards of the 1999/5/EC directive. You may request a full declaration of
conformity from the contact details on the last page of this manual
Should you have any setup problems with the Top Drive Wheel (PSU448/449) please contact our Technical
Support Hotline on +44 (01923) 471 000 – National/International call rates apply or Email
- Spare parts are available for some models at our website www.logic3.com
support@logic3.com