Jammed Brushroll; Power Cord Care - Riccar R40P Manual Del Usuario

MAINTENANCE
SAFETY FIRST
Unplug Vacuum before performing any maintenance on your vacuum.
Replacing Direct
Air Motor Filter
01
Press the handle release pedal with your
foot, and tilt the handle back until it stops.
Press the pedal again to lower the handle to
the floor.
02
Pull the black filter cover latch toremove the
filter cartridge.
03
Discard the used filter cartridge.
04
Insert a new direct air motor filter cartridge
and snap it into place.
05
Return vacuum handle to its upright position.

Jammed Brushroll

01
1/4 turn
TIP
After freeing obstruction and red light is still on, it's likely the clog is located in
the vacuum motor fan. If so, please take your vacuum to an Authorized Riccar
Retailer for service.

Power Cord Care

• If the cord or plug has any apparent damage, refrain from using the vacuum.
Please visit an Authorized Riccar Retailer for a new cord or plug.
• When the vacuum is in use, hold the cord to keep from running over it.
• Avoid obstructions and do not pull the cord around sharp edges or corners.
• Always keep the cord away from heated surfaces and never close doors on it
as this may cause damage to the wiring.
• To unplug, always grasp the plug, not the cord.
10
02
Remove plate
Thermal
Reset
If the Thermal Motor
Protection System shuts
off your vacuum, follow
these steps.
01
Unplug the vacuum.
02
Inspect the vacuum for a full
bag condition or a hose clog
and correct the problem.
03
Locate the Thermal Motor
Protection Reset Button on
the back of the vacuum.
Press the button and
resume vacuuming.
03
Lift