Publicidad
Idiomas disponibles
Idiomas disponibles
English
Battery precautions
1. Do not use rechargeable batteries.
2. Use only 3V, CR2032 battery of the same or equivalent type.
3. Insert batteries with the correct polarity.
4. Keep batteries away from children.
5. Dispose of exhausted batteries according to local legal requirements. Do
not dispose them by throwing away with normal household rubbish.
6. Avoid short circuiting the contacts in the battery compartment and battery
terminals.
7. Remove batteries from the unit if it will not be used for long periods of time.
8. Exhausted batteries should be removed from the battery compartment to
prevent over-discharge, which can cause leakage and may cause damage to
the clock.
Getting started
1. Remove the battery door.
2. Take out button cell battery and remove the plastic strip.
3. Replace the button cell battery for time backup.
4. Close the battery door.
5. An AC/ DC adapter is being used to power the clock, plug the adapter into
the USB-C jack at the back of the clock.
Function keys
ALARM / TIME / 12/24 HOUR / BRIGHTNESS switch.
-Slide to the ALARM position to set the alarm time.
-Slide to the TIME position to set the clock time.
-Slide to the 12/24 HOUR position to set 12/24 hour format.
-Slide to the BRIGHTNESS position to set the clock display brightness.
+ Key
- In the ALARM / TIME setting mode, press to increase the setting value.
Press and hold to speed up the setting. In the 12/24 HOUR setting mode,
press to switch between 12/24 hour format. In the BRIGHTNESS mode,
press to increase the clock display brightness.
– Key
-In the ALARM / TIME setting mode, press to decrease the setting value.
Press and hold to speed up the setting. In the BRIGHTNESS mode, press to
decrease the clock display brightness
ALARM ON/OFF button
- Press to turn the alarm on/off.
SNOOZE zone
-Touch to stop the alarm and activate the snooze function.
RESET button
- Press by using a pin to reset all values to default. In case of a malfunction,
the unit has to be reset.
Product description (Image 1)
LCD display
RESET button
1.
5.
ALARM / TIME / 12/24 HOUR /
ALARM ON/OFF button
2.
6.
BRIGHTNESS switch
SNOOZE zone
7.
USB-C jack
– Key
3.
8.
Backup Battery compartment
+ Key
4.
9.
Display symbols (Image 2)
Time
A.
Alarm icon
B.
Alarm time
C.
Setting the time
1. Slide the "ALARM / TIME / 12/24 HOUR / BRIGHTNESS" switch to the
TIME position.
2. Press the "+" or "-" key to set the desired value. Press and hold to speed up
the setting.
3. Slide the "ALARM / TIME / 12/24 HOUR / BRIGHTNESS" switch to the
"BRIGHTNESS" position to return to normal display and save the setting.
Setting the alarm
1. Slide the "ALARM / TIME / 12/24 HOUR / BRIGHTNESS" switch to the
ALARM position.
2. Press the "+" or "-" key to set the desired value. Press and hold to speed up
the setting.
3. Slide the "ALARM / TIME / 12/24 HOUR / BRIGHTNESS" switch to the
BRIGHTNESS position to return to normal display and save the setting.
Setting the 12/24 hour format
1. Slide the "ALARM / TIME / 12/24 HOUR / BRIGHTNESS" switch to the
12/24 HOUR position.
2. Press the "+" key to set the 12 or 24 hour format.
3. Slide the "ALARM / TIME / 12/24 HOUR / BRIGHTNESS" switch to the
BRIGHTNESS position to return to normal display and save the setting.
Setting the clock display brightness
The clock will automatically adjust the display brightness depending on the
surrounding level of light.
1. In a well-lit environment, slide the "ALARM / TIME / 12/24 HOUR / BRIGHT-
NESS" switch to the BRIGHTNESS position.
2. Press the "+" or "-" key to set the desired brightness.
3. In a dark environment (or by covering the sensor), slide the "ALARM / TIME
/ 12/24 HOUR / BRIGHTNESS" switch to the BRIGHTNESS position.
4. Press the "+" or "-" key to set the desired brightness.
Using the alarm and snooze function
1. Activate the alarm by pressing the "ALARM ON/OFF" button. The bell icon
"
" will appear on the LCD display.
2. Press the SNOOZE zone to stop the alarm and activate the snooze func-
tion. When the alarm sounds, the alarm icon will flash.
3. To de-activate the alarm and snooze function, press the ALARM ON/OFF
button. The bell icon will disappear.
Note:
1. When the snooze function is activated, the alarm will automatically start
again after 5 minutes. The snooze function will not stop unless you press the
ALARM ON/OFF button to turn off the snooze.
2. Do not put the adapter wire near the top of the SNOOZE zone as this will
affect the snooze function.
Battery replacement
1. If the AC/DC adapter is removed from the clock and plugged back in
and the current time is not memorised, then the button cell battery must be
replaced immediately.
2. It is recommended to replace the button cell battery once a year.
Note: Exposure to an electrostatic environment may cause the clock to reset.
In this event please follow the instructions as described in this manual to set
the clock again.
Guarantee
2 year guarantee against material and workmanship defects (except
battery). The guarantee is valid in those countries where the alarm clock
is officially being sold.
Broken or cracked lens screen are not covered under the Guarantee.
Precaution of using adapter:
The AC/DC adapter and apparatus should not be exposed to dripping or
1.
splashing and no objects filled with liquids, should be placed on the AC/DC
adapter and apparatus.
When the AC/DC adapter is used to disconnect device. The AC/DC adapter
2.
should not be obstructed and should be easily accessed during intended
use. To completely disconnect the power input, the AC/DC adapter should be
disconnected from the mains.
Rated power consumption of the LCD clock is DC 5.0V
3.
use the provided DC 5.0V
1.0A adapter for the LCD clock.
Battery should not be exposed to excessive heat such as sunshine, fire or
4.
the like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only
with the same (CR2032) or equivalent type.
Braun helpline
Should you have a problem with your product, please check your local service
centre at:
www.braun-clocks.com
www.braun-watches.com
or contact +44 208 208 1833
WARNING! This product is covered by the Waste Electrical and
Electronic Equipment (WEEE) Directive and the battery used in this
item is covered by the Battery Directive. It should not be discarded with
normal household waste but taken to your local collection centre for
recycling.
This product conforms to the EMC requirements as per council directive
2014/30/EU.
Certain trademarks used under license from The Procter & Gamble Company
or its affiliates.
1.0A, please
Publicidad
