Led Indicator Guide - Roav R3130 Manual Del Usuario

The jump starter will halt power output after 30 seconds,
and will flash on the LED display.
5. After successfully jump starting your car, unplug the jumper
cables within 30 seconds.
• After every successful jump start, the jump starter will reset
automatically. If it fails to jump start your car, remove and
reconnect the clamps after two minutes. After the LED
display shows the voltage, start the car engine.
• DO NOT charge the device immediately after jump starting
your car. Wait at least 30 minutes before charging the
device after a jump start.
• DO NOT crank the engine for more than 3 seconds. Allow
the jump starter to cool down for at least 1 minute after
each attempt.
• If it is extremely hot or cold, wait for several minutes until
the battery works properly (0-60°C).
07 English
All manuals and user guides at all-guides.com
6. Promptly remove clamps from the car battery and put away.
To avoid serious injury to a person or damage to the
jump starter, never attempt to connect the two clamps
together when plugged into the jump starter.

LED Indicator Guide

1. The table below indicates the jump starter is working properly.
LED Display Buzzer Description
The current The clamps are connected correctly.
/
voltage Ready to start the car engine.
English 08