Tabla de contenido
Publicidad
VALUES DURATION COFFEE BREWING
T1 - Brewing short coffee
T3 - Brewing long coffee
The new duration is saved only if superior to 10 seconds.
CONFIGURATION SYSTEM
Configuration water preheating (Plug + T3 activation - T1 T3 ICO1 ICO3 config.)
1.
Insert the plug into the socket while pressing the key T3
2.
After about 1 sec. ICO1 and ICO3 alternately flash quickly to indicate the activation of the
configuration
3.
Release T3
4.
ICO1 flashing function disabled
5.
ICO2 flashing function activated
6.
Press T3 to define the ON / OFF of the function, press T1 to save the setting
7.
Wait for 5 seconds without pressing any buttons to exit the configuration.
8.
Configuration output in "Heating"
Configuration Reset factory parameters
(activation of Plug + T1 + T3 - config. T1 T3 ICO1 ICO3)
1.
Insert the plug into the socket while holding down the buttons T1 and T3.
2.
After about 1 sec. ICO1 and ICO3 quickly flashes ICO1 and then ICO3
3.
Release T1 and T3
Reset to factory parameters (Plug Activation + T1 + T3)
The following parameters are reset to default values:
Duration of T1 and T3 supplies
Preheating: enabled
26
Factory Default
Programmable by user
24 seconds
Minimum 10 sec./Maximum 75 sec.
33 seconds
Minimum 10 sec./Maximum 75 sec.
Publicidad
Tabla de contenido
