Setup Instructions - Eicon Networks Diva 2440 Guía Rápida De Instalación

Setup Instructions

Step 1: Connect the Cables
Leave your computer on when connecting the cables.
As shown below, both the USB and Ethernet ports can be used at
the same time. However, it is recommended that you use only one
port during setup. Once you have verified that you can access the
Internet, you can then connect a second computer.
ADSL
Cable
USB
Cable
To Phone
Jack
ADSL Cable Notes
• Do not install a microfilter on the cable that connects your ADSL
device to the telephone jack.
• If your Diva 2440 has a phone port, make sure you do not use
this port to connect the ADSL cable.
• Several seconds after connecting the ADSL cable, the ADSL
indicator light ( on the front of the device) should start
flashing. This light will stop flashing and stay on when a link has
been established with your ADSL service provider's network.
Ethernet Cable Notes
• The Ethernet port can be used with any computer supporting an
Ethernet card and TCP/IP.
• When connected, the Ethernet indicator light (
the device) will turn green when the Diva 2440 is plugged in and
the computer is on.
• When finished connecting the cables, restart your computer so
that your Ethernet card acquires a new IP address.
USB Cable Notes
• Once the power and USB cables are connected, Windows will
request driver files. Follow the onscreen instructions.
The USB drivers are located in the 'USB' folder on the Diva CD-
ROM.
When installation is complete, click the 'Finish' button. Restart
your computer when asked to do so.
4
Ethernet
Cable
on the front of
Step 2: Enter Account Information
To access the Internet through the ADSL network, you will need to
enter configuration information, such as username and password.
This information is supplied by your ADSL service provider.
The configuration is done through a web browser (Internet
Explorer 4.0 or later, or Netscape Navigator 3.0 or later). An
installer for Internet Explorer for Windows is in the 'bonus' folder
on the Diva CD-ROM.
Make sure you have restarted your computer. (If you are using
1.
the USB port, Windows should have already asked you to do so
upon installation of the USB drivers.)
Launch your web browser.
2.
Click 'File', 'Open', enter 192.168.1.1 then click 'OK'.
3.
Power
Adapter
The Diva 2440 main configuration page should appear.
4.
If you do not see the 'Configuration' page, see
Note:
'Troubleshooting' on page 5.
To continue, see 'Step 3: Complete the Internet Wizard' on
5.
page 5.