Use Instruction - BaByliss 889AE Instrucciones De Montaje

ENGLISH
BABYLISS GENERAL
INSTRUCTIONS
The BaByliss Super Hood Dryer
is protected in its pack and
stable once erected, but care
should be
assembly.
NB:
Never lift the hood by the visor.
The position of the hood is fixed
to give optimum comfort in use.
Do not attempt to adjust the
angle.
ASSEMBLY INSTRUCTIONS
The BaByliss
requires careful
before use. Please read the
following Assembly instructions
carefully:
1. Slide the non-weighted foot
into the
socket (1) until it clicks home.
Insert the
(provided) into hole under
base and tighten to secure
foot. Slide the 3 weighted
feet into the remaining base
sockets (2), (3), (4).
2. Push the plastic lower tube
(5) into the top of the base
segment (10) as far as it will
go, ensuring that the slot in
the lower tube slides over the
ridge inside
segment.
taken during
Super Hood
assembly
extended base
30mm screw
the base
3. Turn the tube connector (7) in
a clockwise direction to
loosen it and release the
upper tube (6). Pull out the
upper tube to the desired
length. Tighten
connector to secure.
4. Fix the drying hood onto the
top of the chrome upper tube
(6), at position (8) making
sure that the hole in the side
of the hood socket is aligned
with the equivalent hole in the
chrome upper tube. Insert
the 12mm screw (provided)
into the aligned holes and
tighten. NB:
stability, always ensure that
the drying hood is positioned
directly
weighted foot (1) of the base.
5. Snap the plastic lead bracket
(9) onto the chrome upper
tube (6) to hold the lead in
position. Then slide the lead
under hook located on top of
base socket (3) (11).
6. The removable filter must
always be in position on the
top of the hood before using
the dryer.

USE INSTRUCTION

• Adjust the height of the hood
to suit your sitting position, via
the tube connector, sliding the
chrome upper tube up or
down as necessary before
re-locking.
• The front visor should be
pushed upwards until it clicks
for optimum
over the
tube
non-
5