Fagor TK-418 Manual De Instrucciones página 10

Switching the kettle back on again
• The kettle can be switched back on
again after being allowed to cool down
for approx. 30 seconds.
5. POURING OUT THE WATER
• Remove the kettle from the power base
and pour out the hot water.
Note
As a result of its functioning, some water
can condense out of the outlet openings
in the base of the kettle and run out
over the edge of the power base. This is
normal and is perfectly harmless.
If the kettle is returned to the power
base, any water left in it will only heat up
if the kettle is switched on again.
6. REMOVE SCALE FILTER
Before removing the scale filter, first remove
the kettle from the power base and allow
to cool down. Never remove the scale filter
while the kettle is still hot or still full of water.
Simply pull the scale filter upwards (fig. 3).
When replacing the filter, ensure that the
scale filter is located properly in its guide.
Press the scale filter down fully into the body.
Note
Never leave the scale filter loose in the kettle.
7. CLEANING AND MAINTENANCE
• Remove the kettle from the power base
and allow it to cool down each time
before cleaning. Disconnect the plug
from the mains.
• Never immerse the appliance or the
power base in water and never use
highly corrosive or abrasive cleaning
agents.
• Wipe out the kettle and power base with
a damp cloth. Rinse out the inside of
the kettle with water. Remove stubborn
stains with washing up liquid.
• To get the best results at all times,
make a regular check to see if there are
particles of scale in the scale filter. Rinse
All manuals and user guides at all-guides.com
9
the scale filter under running water and
use a soft brush if necessary (no metal).
8. DE-SCALING
The kettle must be descaled regularly. At the
latest, the kettle should be descaled when the
time required to boil water is markedly longer or
if it cuts out too soon while heating the water.
Method:
Fill the kettle up the maximum filling level.
Close the lid. The safety lid must click into
place. Connect the power base to the mains
and put the kettle on the power base.
Switch on the kettle. The kettle switches off
automatically once it has boiled the water. Use
any standard descaler (follow the instructions
for use given by the maker). Allow the de-
scaling agent to take effect for at least 30
minutes. Afterwards, rinse out the appliance
several times with clean water and then boil
again with clean water which should then be
poured away.
Repeat the process if the kettle is heavily
scaled.
9. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working
life, the product must not be
disposed of as urban waste.
It must be taken to a special
local authority differentiated
waste collection centre or to
a dealer providing this service. Disposing of a
household appliance separately avoids possible
negative consequences for the environment
and health deriving from inappropriate disposal
and enables the constituent materials to be
recovered to obtain significant savings in energy
and resources.
To remind you that you must collaborate with a
selective collection scheme, the symbol shown
appears on the product warning you not to
dispose of it in traditional refuse containers.
For further information, contact your local
authority or the shop where you bought the
product.