Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARHIHG
The high pressure stream of water that this
_
quipment produces can cut through skin and its
underlying tissues, leading to serious injury and
)ossible amputation.
* NEVER connecthigh pressurehoseto nozzle extension.
. Keephigh pressurehoseconnected to pumpand spraygun
whilesystemis pressurized.
. Alwaysbecertainspraygun,nozzles and accessories are
correctlyattached.
2.
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
3.
Before connecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or have
it replacedif damaged. DO NOTrun pressurewasher if
inlet screenis damaged or missing.
4.
Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
IMPORTANT:DO NOTsiphon standing water for the water
supply. Use ONLY cold water (less than IO0°F).
5.
Connect garden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
NOTICE
Using a OneWay Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
ThereMUSTbe at leastten feet of unrestricted gardenhose
between the pressure washerinletand anydevice,suchas a
vacuumbreaker o r checkvalve.
Damage to equipment r esultingfrom failureto follow this
instructionwill void warranty.
6.
Turn ON the water, press red button (B) on the gun and
squeezethe trigger to purge the pump system of air
and impurities.
WARHIHG
m
Risk of eye injury.
_Spray
can splash back or propel objects.
Alwayswearsafetygoggles whenusingthis equipment o r in
vicinityof whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyouare wearing
adequate safetygoggles.
NEVER substitutesafetyglassesfor safetygoggles.
ChecklistBefore Starting E.gi.e
Reviewthe unit to ensure you have performed all of the
following:
1.
Be sure to read Safety Rubs and Operationsections
before using the pressure washer.
2.
Make sure handle is in place and secure.
3.
Attach battery to handle and make the connection.
4.
Checkthat oil has been added to proper level in engine
crankcase.
5.
Add proper fuel to fuel tank.
6.
Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose.
7.
Provide proper water supply (not to exceed IO0°F).
Battery Float Charger
Use battery float charger jack to keepthe starting battery
charged and readyfor use. Battery charging should be done
in a dry location, such as inside a garage.
1.
Plug charger into unit's "Battery Float Charger" jack (C),
which is located next to the key start. Plug battery
charger into a 120 Volt AO wall receptacle.
/ /_
_©
2.
Unplugcharger from unit and walloutlet when pressure
washer is being started and while it is in operation.
3.
Keep this charger plugged in when pressure washer is
not in use to prolong battery life. The charger has a built
in float equalizer and will not overcharge the battery,
even when plugged in for an extended period of time.
IMPORTANT:See Battery Maintenancefor additional
information.
WARHIHG
Batteryposts,terminals and related accessories contain
lead and lead compounds - chemicalsknownto the State of
California to causecancerand reproductive harm.
Wash handsafter handling.
10
Publicidad
Tabla de contenido
