Service Air Cleaner; Servicespark Plug - Craftsman 580.752280 Instrucciones De Uso

Ocultar thumbs Ver también para 580.752280:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Change oil while engine isstiffwarm from running, a s fellows:
1.
Drain fuel tank by running pressure washer until fuel
tank is empty.
2.
Disconnect spark plug wire and keep it away from spark
plug.
3.
Cleanarea around oil fill, remove oil fill cap/dipstick.
Wipe dipstick clean.
4.
Tip your pressure washer to drain oil from oil fill into a
suitable container making sure you tip your unit away
from spark plug. When crankcase is empty, return
pressure washer to upright position.
5.
Slowly pour recommended oil (about 20 oz.) into oil fill
opening. Pauseto permit oil to settle. Fill to "Full" mark
on dipstick.
6.
Wipe dipstick clean each time oil level is checked. DO
NOT overfill.
7.
Replaceand tighten dipstick.
8.
Wipe up any remaining oil.
9.
Reconnect spark plug wire to spark plug.
Service Air Cleaner
Your engine will not run properly and may be damagedif you
run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of operation or
once eachyear, whichever comes first. Service more often if
operating under dirty or dusty conditions. Replacementsare
available at your local Sears service center.
Toservice the air cleaner,follow thesesteps:
1.
Loosen two screws (A) and lift off cover (B).
2.
Carefully remove air cleaner (C) from base (O).
3.
Install clean (or new) air cleaner in base. Air cleaner
must fit securely in base.
4.
Place cover over air cleaner and tighten screws.
NOTE:You can purchase new air filter elements by calling
1-800-4-MY-HOME(46g-4663).
ServiceSpark Plug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
1.
Cleanarea around spark plug.
2.
Removeand inspect spark plug.
3.
Replacespark plug if electrodes are pitted, burned or
porcelain is cracked. Use the recommended replacement
plug. See Specifications.
4.
Checkelectrode gap with wire feeler gauge and set spark
plug gap to 0.020 inch (0.50 ram) if necessary.
5.
Install spark plug and tighten firmly.
NOTE:You can purchase a new spark plug by calling
1-80O-4-MY-NOIViE ( 469-4663).
Spark ArresterService
Your engine is not factory-equipped with a spark arrester, in
some areas, it is illegal to operatean engine without a spark
arrester. Check local laws and regulations. A spark arrester is
available from your nearest Sears service center. If you need
to order a spark arrestor, please call 1-800-4-1VIY-HOME
(40g-4663).
The spark arrester must be serviced every 50 hours to keep it
functioning as designed.
If the engine has been running, the muffler will be very hot.
Allow the muffler to cool before servicing the spark arrester.
WARHIHG
_
Contact with muffler
result in serious
area can
burns.
_
Exhaustheat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
* DONOTtouch hot partsand AVOID hot exhaustgases.
* Allowequipment t o cool beforetouching.
* Keepat least5 feet (152cm) of clearance on all sidesof
pressure washerincludingoverhead.
* Codeof Federal R egulation (CFR) T itle 36 Parks,Forests,and
PublicPropertyrequireequipment p oweredby an internal
combustionengine to havea sparkarrester,maintained in
effectiveworkingorder,complyingto USDA Forestservice
standard 5100-1Cor later revision.Inthe Stateof California a
sparkarresteris requiredundersection4442 of the California
Publicresources code.Otherstatesmay havesimilarlaws.
Removespark arrester screen for cleaning and inspection.
Replace if screen is damaged.
2O

Publicidad

Tabla de contenido
loading

Tabla de contenido