Craftsman 580.752280 Instrucciones De Uso página 8

B,
,
Attach rope guide (A) through handle with plastic knob
(B). Tighten by hand. Route engine recoil rope through
guide.
Align hose wrap (C) to the back side of accessory tray.
Locate notch with "unlock" icon (8) on hose wrap.
Position notch at top with hose wrap in vertical position.
Clips in the back of accessory tray should slide into the
grooves on the inside surface of hose wrap. Slide hose
wrap on back of accessory tray and rotate 1/8 turn until
"locked"icon (E) is in vertical position. Hose wrap is
easily removed from the accessorytray for wrapping and
unwrapping of the high pressure hose. A clip to secure
the hose on the reel makes it easy to wrap the hose
while it is detached from the accessory tray.
/
7. Attach battery (F) to handle with carriage bolt (G) and
black plastic knob (H). Tighten by hand.
8. Attach battery lead (J) to the similar connection under
the fuel tank. Pressthe ends tightly together by hand.
NOTE:If your battery is discharged,charge prior to use
following the instructions in the section Battery Float Charger.
Attach bottle bracket (K) to handle with carriage bolt (L)
and black plastic knob (M). Tighten by hand.
2-1N-1 SIPHONSYSTEM
The pressure washer is equipped with two detergent
siphoning hoses.
Standard Clear Siphon Tube
Cleartube with filter:
Whenusingthe dear siphontube,dilute
1 part concentrate to 16parts water
(4 oz of standard concentrate makes
1/2gaflonof mix.)
ProjectPro®PerfectMix '_ Siphon
Blue tube with blue bottle cap:
Whenusingtheblue PerfectMix T M siphon,
usetheconcentrate straightfrom the bottle
(Onequartbottle of PerfectMixT'_ concentrate
makes4.25gaflonsof soapspray.)
Attach Project Pro® PerfectMix
TM
Siphon to Pump
Attach the hose end of the blue Project Pro®PerfectMix,M
Siphon (N) to the barbed hose fitting (P) on the pump.
Attach PerfectlVlix,. Detergent Siphon
to Concentrate Bottle
Place Project Pro® PerfectlY]ix 7 _bottle (not included) in the
wire-form bracket on the handle. Removecap from bottle
and insert the Project Pro®PerfectMix,MSiphon (Q). Screw
the siphon unit to the top of the bottle (R). Usethe clip on
the cap (Q) to snap siphon to wire form bracket when siphon
is not in a concentrate bottle.