Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Pressure Washer Rinsing
For Rinsing:
1.
Select and change to desired spray pattern nozzle on
selector nozzle. See How To Use Selector Nozzle.
2.
Keep spray gun a safe distance from areayou plan to
spray.
_i, WARNING
Kickback from spray gun can cause you to
fall.
• Operate pressure washer from a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding, or any other similar location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
3.
Apply a high pressure spray to a small area and then
check surface for damage, if no damage is found, you
can assume it is okay to continue rinsing.
4.
Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Cleaning DetergentSiphoningTube
If you used the clear detergent siphoning tube, you must
flush it with clean water before stopping the engine.
1.
Place detergent siphoning tube/filter in a bucket full of
clean water.
2.
Select and change to SOAP spray pattern nozzle on
selector nozzle. See How To Use Selector Nozzle.
3.
Flush for 1-2 minutes.
4.
Shut off engine following instructions How to Stop
Pressure Washerand turn off water supply.
5.
ALWAYS point spray gun in a safe direction push red
button and squeezespray gun trigger to release retained
high water pressure.
NOTICE Spray gun traps high water pressure, even when
engine is stopped and water is disconnected.
_i, WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
• ALWAYS pointspraygun in safedirection,pressredbutton
andsqueeze sprayguntriggerto release highpressure, e very
time youstop engine.
Automatic Cool DownSystem(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F. The system engages to cool the pump by discharging
the warm water onto the ground.
15
Publicidad
Tabla de contenido
