Power Adhesives 305-12 Manual Instrucciones De Uso página 5

and knowledge, unless they have
been given supervision or instruction
concerning use of the tool by a person
responsible for their safety.
AVOIDING PROBLEMS
• Ensure that tool has reached
temperature before operating.
• Do not leave tool switched on for long
periods without useIf tool is not to be
used for more than 40 minutes, switch
off and restart when required.
• Never lay the tool on its side. Always
use stand provided, the optional bench
stand or the suspension unit.
• Only use adhesives designed for use
with this tool.
• Never remove a partially used glue
stick. This can lead to irreparable
damage.
• Hotmelt glue can be used instead of
nails, staples, tapes, and liquid glues.
However they should not be used in
place of structural connections when
heavy loads are involved.
• Do not use hotmelt glue for objects
that are exposed to extreme heat.
Do not connect to the main supply
at this point!
1. Attach the tool stand
2. Load the tool by inserting an
adhesive stick into the rear
3. Operate the trigger to feed the stick
forward until resistance is felt
1
2
3
4. Connect to main supply and switch
on tool
4
5. Wait 5 minutes to warm
6. Operate the trigger to extrude
adhesive until the stick has been
completely drawn into the rear of the
tool
7. Insert a new stick into the tool
8. To switch off the tool, disconnect
from the mains supply
EN
2