Rear View Camera Settings; Additional Information; Precautions; Notes On Lcd Panel - Sony XAV-62BT Manual De Instrucciones

Rear view camera settings

You can display setting items on the picture from
the rear view camera to assist operation.
This setting is available only when:
– "Camera Input" is set to "ON" (page 50).
– the parking brake is applied.
1
Touch "Source List," then
The general setting menu appears. If not,
touch "General."
2
Touch v/V to scroll, then touch "Rear
View Camera Setting."
The setting items appear.
Back
Turn off engine but keep the key in the "IGN" position.
Displaying marker lines
Touch "Marker."
Touch "Marker" again to hide the marker lines.
Reversing the picture
Touch "Mirror."
A mirror-reversed picture appears.
Editing lines
1 Touch "Line Edit."
Back
1 Edit
2 Edit
3 Edit
Turn off engine but keep the key in the "IGN" position.
2 Select the line to edit.
Touch "1 Edit," "2 Edit," or "3 Edit"
corresponding to the line to edit.
3 Edit the line.
To increase the length, touch B b.
To reduce the length, touch bB.
To adjust the position, touch V or v.
To restore the default setting, touch "Reset."
To return to the previous display, touch "Back."
58
.
Marker
Mirror
1
2
3
Line Edit
1
2
3
Reset

Additional Information

Precautions

• Cool off the unit beforehand if your car has been
parked in direct sunlight.
• Power antenna (aerial) extends automatically.
Moisture condensation
Should moisture condensation occur inside the unit,
remove the disc and wait for about an hour for it to
dry out; otherwise the unit will not operate properly.
To maintain high sound quality
Do not splash liquid onto the unit or discs.

Notes on LCD panel

• Do not wet the LCD panel or expose it to
liquids. This may cause a malfunction.
• Do not press on the LCD panel as doing so can
distort the picture or cause a malfunction (i.e., the
picture may become unclear, or the LCD panel
may be damaged).
• Do not touch other than with the finger, as it may
damage or break the LCD panel.
• Clean the LCD panel with a dry soft cloth. Do not
use solvents such as benzine, thinner,
commercially available cleaners, or antistatic
spray.
• Do not use this unit outside the temperature range
5 – 45 ºC (41 – 113 ºF).
• If your car was parked in a cold or hot place, the
picture may not be clear. However, the monitor is
not damaged, and the picture will become clear
after the temperature in your car becomes normal.
• Some stationary blue, red or green dots may
appear on the monitor. These are called "bright
spots," and can happen with any LCD. The LCD
panel is precision-manufactured with more than
99.99% of its segments functional. However, it is
possible that a small percentage (typically 0.01%)
of the segments may not light up properly. This
will not, however, interfere with your viewing.