Dc Connection Precautions - Schumacher Electric SP1 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

a battery without removable cell caps, such as valve regulated
lead acid batteries (VRLA), carefully follow the manufacturer's
recharging instructions.
3.5
Read, understand and follow all instructions for the charger,
battery, vehicle and any equipment used near the battery
and charger. Study all of the battery manufacturer's specific
precautions while charging and recommended rates of charge.
3.6
Determine the voltage of the battery by referring to the vehicle
owner's manual and make sure that the output voltage is correct.
3.7
Make sure that the charger cable clips make tight connections.
4.
CHARGER LOCATiON
RiSK OF EXPLOSiON ANd CONTACT WiTH BATTERY ACid.
corrode and damage the charger.
4.3
Do not set the battery on top of the charger.
4.4
Never allow battery acid to drip onto the charger when reading the
electrolyte specific gravity or filling the battery.
4.5
Do not operate the charger in a closed-in area or restrict the
ventilation in any way.
5.

dC CONNECTiON PRECAUTiONS

5.1
Connect and disconnect the DC output clips only after setting
all of the charger switches to the "off" position (if applicable) and
removing the AC plug from the electrical outlet. Never allow the
clips to touch each other.
5.2
Attach the clips to the battery and chassis, as indicated in
sections 6 and 7.
4.1
Locate the charger as
far away from the battery as
the DC cables permit.
4.2
Never place the
charger directly above the
battery being charged;
gases from the battery will
•5•

Publicidad

Tabla de contenido
loading

Tabla de contenido