Urmet 1092 Manual De Usuario página 19

INSTALLATION
1. Before starting to wire, make sure that all the units to be connected are OFF.
2. Unscrew the fixing base from the ring lock to separate the camera, as in figure.
3. Fix the base to the surface with 4 screws. If it is not planned an hidden installation of connection
cables, use the slot present on the base to draw out the connection cables present on the camera
body, without pinching them, in order to avoid malfunction.
4. Bring the cover near the fixing base and screw the ring lock to the fixing base without tightening.
5. Adjust the camera slant as regards the desired image capture point.
6. Screw tightly the ring lock to the camera base.
7. Connect the video output to the selected user device.
8. Power the camera.
9. Adjust the lens to frame the required images.
Focus adjustment
10. Turn the VARIFOCAL adjustment screw (
or away.
11. Turn the focus adjustment screw (
subjects.
DS 1092-186
PROTECTIVE
DOME
RING LOCK
N
Ⓓ
T
Ⓒ
) , clockwise or anticlockwise, to adjust focus of nearby or faraway
Ⓓ
FIXING BASE
BODY CAMERA
∞
VARIFOCAL adjustment
W
) , clockwise or anticlockwise, to move the subject closer
Ⓒ
19