Urmet 1092 Manual De Usuario página 30

REMARKS ON PRIVACY ZONE
•
It is suggested to use privacy zones lightly bigger than areas to be masked.
•
Privacy zones can only be rectangular.
Select this option to activate (ON) the privacy zones and access the following submenu.
SELECT
DISPLAY
COLOR
TRANS.
DEFAULT
RETURN
Option
SELECT
DISPLAY
COLOR
TRANS.
DEFAULT
DEFECT - DEAD PIXEL COMPENSATION ( DAMAGED PIXEL COMPENSATION)
This function allow to repair sensor single pixels under low light condition, reducing the brightness of the
too bright pixels. Press the button "START" (present in the menus WHITE DPC and BLACK DPC), the
message "Close the iris then press Enter" will be displayed. Cover the lens with a black lid to prevent light
from passing through. Make sure the image is totally dark and not cover the light sensor (CDS), in order the
leds are not turned on (if leds are turned on, they become red).
Press again the button "ENTER", the message "Waiting....." will be displayed and the compensation
process will start. After few seconds, the menu will go back to the previous level. If the camera doesn't go
back to the previous menu level (because it has not been totally darkened or because leds were on), switch
off and switch on the camera and repeat the operation.
Don't modify the default values of the shown parameters in the DPC menu.
LIVE DPC
WHITE DPC
BLACK DPC
RETURN
30
PRIVACY
AREA1
COLOR
WHITE
1.00
RET
Value
AREA1 ÷ AREA4
COLOR ÷ INV ÷
MOSAIC ÷ OFF
CYAN ÷ USER ÷
WHITE ÷ BLACK ÷
RED ÷ BLUE ÷
YELLOW ÷ GREEN
0.25 ÷ 1.00
/
DEFECT
ON
ON
OFF
RET
This option allows to select one or more of the 4 available
privacy areas. It is possible to define the number of areas
to be displayed on the screen and the size of each single
area. (see below).
This option allows to define dimension and position on the
screen of the selected area and type of mask: full color,
negative image or mosaic.
It allows to select one of the available colors to fill the
previously selected area.
It allows to set the transparency level.
It allows to restore the default settings.
Description
DS1092-243