Philips WP3890/01 Manual Del Usuario página 14

Open the appliance door (1). Pull the filter
2
towards you with the lever (2) and slightly
tilt the filter.
Turn the filter cap (1) and remove it (2).
3
Grab the handle on top of the filter (1) and
4
slowly pull the filter out of the holder (2).
Put a new filter in the filter holder.
5
1
Align the arrow on the cap with the arrow
6
on the filter housing and press the cap down
firmly (1). Turn the cap clockwise to fix it (2).
Push the filter holder back into place (1) and
7
close the appliance door (2).
Note:
D
Each time you replace the filter, make sure you
also clean the macro filter (see section 'Cleaning
the macro filter' above).
Once you have replaced the filter, you have to
confirm replacement of the filter. The pure water
dispenser only operates normally again after you
confirm replacement of the filter.
7.0.5 Confirming filter replacement
Switch on the pure water dispenser.
1
• If you replaced the filter during the warning
period (between 2700 and 3000 litres),
the filter indicator c flashes. Wait until the
dispense button d starts flashing (ready to
dispense - manual mode).
• If you replaced the filter after filter expiry,
the filter indicator lights up continuously.
Press and hold the MUSIC button
2
and then press and hold the dispense