Publicidad
Idiomas disponibles
Idiomas disponibles
SF 0156
when you go out for long time.
• Never use the fan before finishing assembly to avoid any
hurts.
PARTS:
A. Tilt adjustment knob
B. Rotation knob
1. Front grill
2. Plastic rim
3. Rim screw
4. Blade screw
5. Fan blade
6. Grill nut
7. Rear grill
8. Motor assembly
9. Motor shaft
10. Thumb screw
11. Height adjustment knob
12. Telescopic tube
13. Base
14. Switch
ASSEMBLY
1. Base assembly:
Assemble the base of the fan, by
placing the two parts in the shape of a
cross and apply the telescopic tube.
Place the Wing nut and tighten. Insert
the telescopic tube and secure with
the nut.
2. Motor assembly:
Place the motor assembly with the telescopic tube and Install the motor housing on the telescopic tube and
tighten the plastic nut (10) to secure.
Position the rear rack (7) through the motor shaft and secure with the nut on the grill (6). Install blade (5) and
secure with screw blade (4).
Place the front grill (1) and secure it with the plastic ring (2) to the rear rack (7). Tighten the ring (3) to install
the grilles firmly.
OPERATION
• Place the assembled fan on a flat, level, firm and dry surface.
• Plug the power cord into a polarized 230 volt AC wall outlet.
• Turn the fan on and select the desired running speed with the speed control switch conveniently
and safely located at the front of the fan below the front grill (0 – off; 1 – low; 2 – medium; 3 high)
• To set the fan into oscillation, depress the oscillation knob on the top of the motor assembly. The fan
head will pivot side to side and up and down (B).
• For stationary operation, pull up on the oscillation knob.
• To set the timer, set the knob to the desired minutes when time runs out, the fan stopped working
8
Publicidad
