Kenwood KAC-6202 Manual De Instrucciones página 6

Connection
■ Terminal names
6 Fuse (25 A)
7 Battery terminal
8 Ground terminal
9 Power control terminal
Controls the unit ON/OFF.
NOTE
Controls the unit power. Be sure to connect it
with all the systems.
0 Speaker output terminals
• Stereo Connections:
When you wish to use the unit as a stereo
amplifier, stereo connections are used.
The speakers to be connected should have an
impedance of 2Ω or greater. When multiple
speakers are to be connected, ensure that the
combined impedance is 2Ω or greater for each
channel.
• Bridged Connections:
When you wish to use the unit as a high-
output monaural amplifier, bridged
connections are used. (Make connections to
the LEFT channel 9 and the RIGHT channel ·
SPEAKER OUTPUT terminals.)
The speakers to be connected should have an
impedance of 4Ω or greater. When multiple
speakers are to be connected, ensure that the
combined impedance is 4Ω or greater.
CAUTION
2
The rated input of the speakers should be no
less than the maximum output of the amplifier.
Otherwise malfunction may result.
! LINE IN terminal
6
English
6 7 8 9 0
@ RCA cable ground lead terminal
When using an RCA cable with a ground lead
attached, connect the ground lead to this
terminal.
# Speaker level input terminals
• The genuine-accessory car stereo shall have a
• Do not connect the speaker output leads from
• Do not connect cables and leads to both RCA
• Connect the power control lead to a power
@ #
!
NOTE
maximum power output of no more than 40 W.
a power amplifier (Optional) to the speaker
level input terminals of this unit, for this may
cause malfunction or damage.
cable input jacks and the speaker level input
terminals simultaneously, for this may cause
malfunction or damage.
supply which can be turned ON/OFF by
the ignition key switch (ACC line). With this
connection, shock noise may be generated
when the power of the genuine-accessory car
stereo is switched ON/OFF.