Multilaser Explorer Manual Del Usuario página 46

DIN REAR MOUNT & INSTALL AND REMOVE THE FRONT PANEL
DIN REAR MOUNT (method B)
• Instalación usando los orificios de los tornillos en los lados de la unidad
NOTE:
User's manual
• Installation using the screw holes on the sides of
the unit
Fastening the unit to the factory radio mounting bracket:
1. Select a position where the screw holes of the bracket and the
screw holes of the main unit become aligned (are fitted) and tighten the
screws at 2 places on each side. Use either truss screws (5x5 mm) or flush
surface screw (4x5 mm).
2. Screw ("T" Position).
3. Dashboard or Console.
NOTE:
The mounting box, outer trim ring, and half-sleeve are not used for
method B installation.
• Install and Remove the Front Panel
Remove the front panel
Press "PWR" button in the upper left corner .
Please see picture 1 .
Press "REL" button in the and the pull it out.
Please see picture 2.
• Install the front panel
Put notch A (shown as picture) onto buckle B, and then slightly press
into the right side.
Please see picture
Please don't use your finger on the control panel, may cause the con-
nector contact, if connectors dirty application of clean soft cloth to
wipe clean.
46