Error Codes - Reliable SEWQUIET 6000SM Manual De Instrucciones

HOW TO ENABLE AND DISABLE THE NEEDLE
POSITIONING FUNCTION
• Press the "P" button 2 times and the LED will change to n1
• Press the "S" button to select between "0" and "1"
• Select "0" to disable the needle positioning function
• Select "1" to enable the needle positioning function
• Press the "P" button to save the selection
HOW TO SET THE STOP POSITION OF THE NEEDLE
• Press the "P" button 3 times and the LED will change to n2
• Press the "S" button to select between "0" and "1"
• Select "0" and the needle will stop in the down position
• Select "1" and the needle will stop in the up position
• Press the "P" button to save the selection

ERROR CODES

ERROR CODE
E1: Operational failure.
E2: Over current or under voltage.
E3: The board cannot read the
parameter.
E4: Hall signal error.
E5: Needle position problem.
SOLUTION
E1: Machine is locked. Check to see if the
machine is difficult to turn, or if there is a
lack of lubrication.
E2: Check the power source to ensure that
the voltage is within range.
E3: Turn the power off and on twice, and
try again. If the problem still cannot be
solved, contact your dealer.
E4: Replace the main fuse. If the problem
continues to persist, please contact your
dealer.
E5: Check if the synchronizer is connected.
04