Makita HR2621 Manual De Instrucciones página 7

Insert the bit into the tool. Turn the bit and push it in until
it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
014501
Bit angle
(when chipping, scaling or demolishing)
1
014363
The bit can be secured at the desired angle. To change
the bit angle, rotate the action mode changing knob to
the O symbol. Turn the bit to the desired angle.
014364
Rotate the action mode changing knob to the
Then make sure that the bit is securely held in place by
turning it slightly.
Depth gauge
The depth gauge is convenient for drilling holes of
uniform depth.
1. Bit
2. Chuck cover
2
1. Action mode
changing knob
symbol.
1
3
014431
Press the lock button on the grip base in the direction of
arrow shown in the figure and with the lock button being
pressed insert the depth gauge into the hex. hole in the
grip base.
1
2
014432
At this time, the depth gauge needs to be inserted so
that its toothed side is directed to the toothed side of
hex hole marking on the grip base as shown in the
figure.
014429
Adjust the depth gauge to the desired depth by moving
it back and forth while pressing the lock button. After the
adjustment, release the lock button to lock the depth
gauge.
1
014434
7
1. Grip base
2 2. Lock button
3. Depth gauge
1. Toothed side of
hex hole marking
on the grip base
2. Toothed side of
the depth gauge
1. Lock button
1
1. Toothed side of
hex hole marking
2
on the grip base
2. Toothed side of
the depth gauge