Operation - Briggs & Stratton ELITE Serie Manual Del Operario

Ocultar thumbs Ver también para ELITE Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION

NOTE: Use an automotive hydrometer to test battery
state of charge and condition. Follow the hydrometer
manufacturer's instructions carefully. Generally, a battery is
considered to be at 100% state of charge when specific
gravity of its fluid (as measured by hydrometer) is 1.260 or
higher.
HOW TO USE THE
BATTERY CHARGER
Use battery float charger jack to keep the starting battery
charged and ready for use. Battery charging should be done
in a dry location, such as inside a garage.
1.
Plug charger into unit's "Battery Float Charger" jack,
which is located on starter switch (Figure 9). Plug
battery charger into a 120 Volt AC wall receptacle.
Figure 9 — Battery Charger Jack
2.
Unplug charger from unit and wall outlet when
generator is being started and while it is in operation.
3.
Keep this charger plugged in when generator is not in
use to prolong battery life.The charger has a built in
float equalizer and will not overcharge battery, even
when plugged in for an extended period of time.
IMPORTANT: See "Battery Maintenance" on page 18 for
additional information.
COLD WEATHER
OPERATION
Under certain weather conditions (temperatures below
40°F [4°C] combined with high humidity), your generator
may experience icing of the carburetor and/or the
crankcase breather system.To reduce this problem, you
need to perform the following:
1.
Make sure generator has clean, fresh fuel.
2.
Open fuel valve (turn valve to open position).
3.
Use SAE 5W-30 oil (synthetic preferred, see engine
operator's manual).
4.
Check oil level daily or after every eight (8) hours of
operation.
5.
Maintain generator following "Maintenance Schedule"
in engine operator's manual.
6.
Shelter unit from elements.
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Elite 09801-9

Tabla de contenido