Cold Weather Operation - Briggs & Stratton ELITE Serie Manual Del Propietário

How to Use the Battery Charger
Use battery float charger jack to keep the starting battery
charged and ready for use. Battery charging should be done
in a dry location, such as inside a garage.
• Plug the charger into the unit's "Battery Float Charger"
jack, which is located on the starter switch (Figure 8).
Plug battery charger into a 120 Volt AC wall receptacle.
Figure 8 — Battery Charger Jack
• Unplug the charger from the unit and the wall outlet when
generator is being started and while it is in operation.
• Keep this charger plugged in when generator is not in
use to prolong battery life.The charger has a built in float
equalizer and will not overcharge the battery, even when
plugged in for an extended period of time.
IMPORTANT: See "Battery Maintenance" on page 14 for
additional information.
10000W Generator
COLD WEATHER
OPERATION
Under certain weather conditions (temperatures below
40°F [4°C] and a high dew point), your generator may
experience icing of the carburetor and/or the crankcase
breather system.
Build a structure that will enclose three sides and the top
of the generator:
• Make sure entire muffler-side of generator is exposed.
Note that your generator may appear different from that
shown in Figure 9.
Figure 9 — Permanent Cold Weather Shelter
• Ensure a minimum of two feet clearance between open
side of box and nearest object.
• Face exposed end away from wind and elements.
• Enclosure should hold enough heat created by the
generator to prevent problems.
CAUTION
enclose generator any more than shown. Remove
generator from shelter when temperature is above
40°F [4°C].
10
Wind
! NEVER run unit indoors. DO NOT