Steam Ironing - Brentwood Appliances MPI-90R Instrucciones De Operación Y Seguridad

Ocultar thumbs Ver también para MPI-90R:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Identifying your Garment:
GARMENT LABEL
Using Your Steam Iron:

STEAM IRONING

Filling the Reservoir:
1. Check that the plug is disconnected from the socket.
2. Move the steam knob B to "O" [Fig. 1].
3. Raise the tip of the iron to help the water enter the opening without overflowing.
4. Slowly pour the water into the reservoir using the special measure and taking care
not to go over the maximum level (about 170ml) indicated by "MAX" on the
reservoir.
Selecting the Temperature:
1. Put the iron in a vertical position.
2. Put the plug in the socket.
3. Adjust the temperature knob (H) according to the international symbol on the
garment label [Fig. 3]. The power light (E) indicates with a red light that the iron is
heating up. Wait until the power light turns green before ironing.
Warning: during ironing, the power light comes on at intervals, indicating that the
selected temperature is maintained. If you lower the selected temperature after
ironing at a high temperature, do not start ironing until the power light comes on
again.
Selecting the Steam:
1. The quantity of steam is regulated by the steam knob (B).
2. Turn the steam knob to a position between minimum and maximum depending
on the quantity of steam required and the temperature selected.
Warning: the iron gives off steam continuously only if you hold the iron horizontally.
You can stop the continuous steam by placing the iron in a vertical position or by
moving the steam knob to "O". As indicated on the steam knob (H) and in the initial
table, you can only use steam at the highest temperatures. If the selected
temperature is too low, water may drip onto the plate.
Selecting Shot-Steam and Steam when Ironing Vertically:
1. Press the shot-steam button (C) to generate a powerful burst of steam that can
penetrate the fabrics and smooth the most difficult and tough creases. Wait for a
few seconds before pressing again [Fig. 4].
2. By pressing the shot-steam button at intervals you can also iron vertically (curtains,
FABRIC TYPE
Synthetic
Silk - Wool
Cotton - Linen
Fabric should not be ironed
5
THERMOSTAT REGULATION
low temperature
●●
medium temperature
●●●
high temperature

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mpi-90bMpi-90w

Tabla de contenido