Dry Ironing; Spray Function - Brentwood Appliances MPI-60 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Selecting the Temperature:
NOTE: Always check garment label for ironing instructions before ironing
garment. If the instructions are missing, then use the table below.
1. Insert the plug into the wall outlet and stand Iron upright
2. Turn the temperature control dial (1) to the desired temperature.
3. The power indicator light will turn off once temperature has been reached.
Note: The light will turn on and off indicating that the selected temperature is
being maintained.
Selecting the Steam:
Selecting Shot-Steam and Steam when Ironing Vertically:
1. Press the shot-steam button (F) to generate a powerful burst of steam
that can penetrate the fabrics and smooth the most difficult and tough
creases. Wait for a few seconds before pressing again [Fig. 4].
2. By pressing the shot-steam button at intervals you can also iron
vertically (curtains, hung garments, etc.) [Fig. 6].
Warning: the shot-steam function can only be used at high temperatures.
Stop the emission when the power light comes on, and then start ironing again
only after the light has gone off.

DRY IRONING

To iron without steam, follow the instructions in section "Steam Ironing",
leaving the steam selector (D) on position "O".

SPRAY FUNCTION

1. Make sure that there is water in the reservoir.
2. Press the spray button (E) slowly (for a dense spray) or quickly (for a
vaporized spray) [Fig. 2].
Warning: for delicate fabrics, we recommend moistening the fabric
5

Publicidad

Tabla de contenido
loading

Tabla de contenido