Greencut GLM560L-16 Manual De Instrucciones página 58

Ocultar thumbs Ver también para GLM560L-16:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

58
MULCHING TIPS
NOTE: Inspect the area where the mower is to be used and remove all stones, sticks, wire, bones,
and other debris that might be thrown by the rotating blade.
Release the switch to turn the mower OFF when crossing any graveled area (stones can be thrown by the blade).
Set mower to the highest cutting height when mowing on uneven ground or in tall weeds.
For effective mulching, do not cut wet grass because it tends to stick to the underside of the deck, preventing proper
mulching of grass clippings. New or thick grass may require a narrower cut. The ground speed should be adjusted
to the condition of the lawn. If mowing has been delayed and the grass has been allowed to grow longer than 4 in.
(10 cm), mow the lawn twice in order to reduce the grass height to a maximum of 3-3/8 in. (8.5 cm).
Walk at a steady pace. Overlap the cutting rows. Do not let the grass get too tall. If the grass gets too long, start
at the highest cutting position and work down to the desired cutting height.
ATTENTION: If you strike a foreign object, stop the motor and remove the battery. Thoroughly
inspect the mower for any damage. Repair any damage before operating the mower. Excessive
vibration of the mower during operation is an indication of damage. Thoroughly inspect the mower
and repair any damage before operating the mower.
EMPTYING THE GRASS CATCHER BAG
Stop the mower and allow blades to completely stop.
Lift the rear discharge cover.
Lift the grass catcher by its handle to remove from mower.
Empty grass clippings.
Lift the rear discharge cover and reinstall the grass catcher as described
earlier in this manual.
NOTE: When you start the mower, the full bag indicator of
the grass catcher will lift up. Once the grass catcher is full,
the full bag indicator will fall. So the grass catcher bag
needs to be emptied.

Publicidad

Tabla de contenido
loading

Tabla de contenido