Furman Elite-10E i Manual De Usuario página 5

please contact Furman Customer Service. Fill out and return your warranty registration card. Registration is recommended
because it can be used to establish whether the unit is within the warranty period should your original ownership
documents be lost, and it assists us in informing you about upgrades or other vital information.
Safety Information - Warnings
Please read and observe all of the safety and operating instructions before the Elite-10E i is operated. Retain these
instructions for future reference.
• Do not disassemble or modify in any way. No user-serviceable parts inside
• Keep away from moisture and avoid excessive humidity
• Do not allow liquids or foreign objects to enter the unit
The Elite-10E i should be serviced by qualified service personnel when:
• The power supply cord or plug has been frayed or cut.
• Objects have fallen or liquid has spilled into the unit.
• The Elite-10E i has been exposed to rain or other moisture.
• The Elite-10E i does not appear to operate normally, or exhibits a marked change in performance.
• The Elite-10E i has been dropped, or the enclosure damaged.
Power Source
The power source to which the Elite-10E i is connected should be adequate for use at 10 Amps.
Placement
The Elite-10E i is manufactured with four rubber feet for placement on any table, cabinet, shelf, or floor. These rubber feet
may be easily removed with a standard Philips screw driver when rack mounting adjacent to other components. Placement
or proximity to other components is not critical, and the Elite-10E i does not produce any appreciable heat under standard
use. The Elite-10E i may also be rack mounted in a standard 19" (483mm) rack by attaching the Elite-10E i rack ears. They
are attached to the chassis by installing each rack ear with (3) pan-head Philips screws contained within the Elite-10E i rack
mounting kit. The third screw used for each rack ear is for the center hole, located towards the rear and aids in stabilizing
the unit when rack mounted.
Connection
AC Cable Routing
The Elite-10E i's male AC cord must be connected to an appropriate socket (see current rating recommendation above as
well as the Furman international website for optional AC cords if the standard cord is not suitable for your area).
Connecting Components to the Digital - Video Component AC Outlet Banks
The Elite-10E i's two "Video Component AC Outlets" should be employed for critical video components such as DVD players,
projectors, plasma, or LCD video screens.
Connecting Components to the Linear Filtering Power Banks
The Elite-10E i's four rear panel "Audio – Audio-Video AC Outlets" should be employed for any component not connected
to the "Video Component AC Outlets" . These outlets still possess exceptional AC noise filtering to maximize system
performance.