Publicidad
Idiomas disponibles
Idiomas disponibles
e
®
Retractable Front Panel Lights and Dimmer Control
The Elite-10E i includes a front panel mounted dimmer control for the two retractable front panel light tubes. The dimmer
knob controls the brightness of both light fixtures. Turn it clockwise to increase brightness; turn it counter-clockwise to
decrease brightness. When the light tubes are fully inserted flush to the front panel, the light circuit is turned off via an
internal micro-switch. Whether the light tubes are retracted or nearly flush with the front panel, there will be no appreciable
heat regardless of dimmer setting due to the efficiency of our full light spectrum LED's.
AC Voltage Meter
Your Elite-10E i contains a precision AC voltage meter. The meter continuously monitors and displays the incoming AC
voltage (+/- 2VAC typically).
Suggested AC Connection
Cable/Satellite
Protectors (x4)
AC Cord
Soft Start - Continuous Use
When power is first applied to the Elite-10E i, (the front panel breaker-power toggle must be switched to the "1" position) the
Soft Start feature is activated. There is an audible "clack" when the Elite-10E i is first turned on or off. This sound is produced
by the Soft Start circuit's 30 Amp relay engaging or disengaging. There is virtually nothing in the Elite-10E i's construction,
design, or componentry to wear over the life time of the product, and there is no power draw from your electric service
meter aside from the LED power indicator, lamps, and relay circuits. For this reason the Elite-10E i may be left with its power
engaged permanently at a negligable cost per month.
AC Transient Voltage Surge Suppression and Extreme Voltage Shutdown
Extreme Voltage Shutdown Indicator:
This LED is normally off. It monitors AC wiring faults – for example, accidental connection to an open neutral in some
countries or a connection well in excess of 300VAC. The Series Multi-stage Protection (SMP) circuit senses voltages that are
so high that operation would be impossible and shuts the power down before damage can occur. Upon initially applying
power to these units, the Extreme Voltage indicator LED will light if the input voltage is above the extreme voltage cutoff,
and power will not be applied to the unit's outlets. If the unit has been operating with an acceptable input voltage and
subsequently that voltage exceeds 275V, it will shut off power to the outlet and the Extreme Voltage LED will light. Manual
re-set of the power switch will be necessary once the over voltage has been corrected or the unit is plugged into an
appropriate outlet.
Protection OK Indicator:
Although the Furman SMP circuit assures virtually maintenance free protection from transient voltage spikes and surges,
nature has a way of occasionally creating electrical forces that are beyond the capabilities of any Transient Voltage Surge
-10
O
'
M
i
lite
e
wner
s
anual
Audio Processor
A/V Receiver
CD/SACD
Player
Plasma/LCD Monitor/
Projector
Satellite Receiver/
Cable Box/DVR
2 - 7 Channel
Amplifier
DVD/HD-DVD/
Blu-Ray Player
Video Scaler
Publicidad
