Washer/Dryer Care; Cleaning The Washer/Dryer Location; Cleaning The Dryer Interior; Removing Accumulated Lint - Maytag MGT3800TW2 Instrucciones Para El Usuario

Cleaning the Washer/Dryer Location

Keep washer/dryer area clear and free from items that would
obstruct the flow of combustion and ventilation air.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Failure to do so can result in death, explosion, or fire.
Cleaning Your Washer
Cleaning the exterior
Use a soft, damp cloth or sponge to wipe up any spills such as
detergent or bleach. Occasionally wipe the outside of your washer
to keep it looking new.
Cleaning the interior
Clean your washer interior by mixing 1 cup (250 mL) of chlorine
bleach and enough detergent to equal twice the manufacturer's
recommended amount for a normal wash load. Pour this mixture
into your washer and run it through a complete cycle using hot
water. Repeat this process if necessary.
NOTE: Remove any hard water deposits using only cleaners labeled
as washer safe.
Cleaning the liquid fabric softener dispenser (on some models):
1. Remove dispenser by grasping top with both hands and
squeezing, while pushing upward with thumbs.
2. Rinse dispenser under a warm water faucet, then replace it.
NOTE: If your model has a liquid fabric softener dispenser, do not
wash clothes with this dispenser removed. Do not add detergent or
bleach to this dispenser; it is for liquid fabric softener only.
Water Inlet Hoses
This washer does not include water inlet hoses. Whirlpool
Corporation recommends use of factory specified parts. A list of
factory specified hoses available for separate purchase are listed on
the first page of this user instructions. These hoses are manufactured
and tested to meet Whirlpool Corporation's specifications.
Replace water inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace water inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your water inlet hoses, mark the date of
replacement on the label with a permanent marker.
Cleaning the Lint Screen
Clean the lint screen before each load. A screen blocked by lint can
increase drying time.
IMPORTANT:
■ Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.

WASHER/DRYER CARE

■
Style 1:
1. The lint screen is located inside the dryer on the back wall. Pull
2. Separate the cover and the screen by squeezing the screen and
3. Roll lint off the screen with your fingers. Do not rinse or wash
4. Put the lint screen and cover back together and push firmly back
Style 2:
1. The lint screen is located inside the dryer in the front door well.
2. Roll lint off the screen with your fingers. Do not rinse or wash
3. Push the lint screen firmly back into place.
Laundry detergent and fabric softener residue can build up on the
lint screen. This buildup can cause longer drying times for your
clothes, or cause the dryer to stop before your load is completely dry.
The screen is probably clogged if lint falls off the screen.
Clean the lint screen (as outlined following) every 6 months, or more
frequently if it becomes clogged due to a residue buildup.
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Replace screen in
To clean dryer drum
1. Apply a nonflammable household cleaner to the stained area of
2. Wipe drum thoroughly with a damp cloth.
3. Tumble a load of clean cloths or towels to dry the drum.
NOTE: Garments that contain unstable dyes, such as denim blue
jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will not stain
future loads of clothes. Dry unstable dye items inside out to avoid
transfer of dye.
Lint should be removed every 2 years, or more often, depending on
dryer usage. Cleaning should be done by a qualified person.
Lint should be removed every 2 years, or more often, depending on
dryer usage.
If lint falls off the screen into the dryer during removal, check the
exhaust hood and remove the lint.
Every Load Cleaning
out the lint screen and its cover.
pulling on the cover at the same time.
screen to remove lint. Wet lint is hard to remove.
into place.
Pull the lint screen straight up.
screen to remove lint. Wet lint is hard to remove.
As Needed Cleaning
lint screen with the brush to remove residue buildup.
dryer.

Cleaning the Dryer Interior

the drum and rub with a soft cloth until stain is removed.

Removing Accumulated Lint

From Inside the Dryer Cabinet
From Inside the Exhaust Vent
7