Installation - Compaq mv540 Guía De Usuario

Installation

Before installing your monitor, place it in a convenient, well-ventilated location near your computer,
ensure that power to your computer and other peripheral devices is turned off, and proceed as follows:
Insert the speaker power cable or adapter plug 1 into the back of the right speaker
1.
plug from the left speaker into the socket on the back of the right speaker
Insert the other end of the speaker power cable 3c c c c into the back of the monitor
2.
Connect the lime green plug from the right speaker 2 to the audio out
3.
your computer.
4. Connect the pink end of the microphone cable to the microphone socket
your monitor 3b b b b , then plug the other end of the cable into the microphone connector on the rear
panel of your computer 6.
5. Connect the monitor signal cable from the back of the monitor to the blue socket on the back of the
computer 4. Tighten the screws on the end of the connector.
IMPORTANT: Ensure that the signal cable aligns with the 15-pin connector. Do not force the cable onto
the connector or you may damage the signal cable.
( Installation instructions continued on next page .)
4
. Insert the
.
.
socket on the back of
on the back panel of