Briteq LDP-COBWASH WW Serie Manual De Instrucciones página 7

ENGLISH
ELECTRICAL INSTALLATION + ADDRESSING
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Master / Slave mode:
Connect the projectors together as shown on the drawing. Please refer to the paragraph "SETUP MENU" to
setup the master. You can also switch the IR-remote on the master to ON and use the included IR-remote.
All slaves must be set to SLAVE-mode. You can put as many slaves as you like on condition that the overall
power consumption on the power line stays under 10A (2300W).
IMPORTANT: make sure that no DMX-controller is connected, this will result in unexpected behavior!
Electrical installation for two or more units in DMX-mode:
 The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected units.
 Use the supplied DMX input conversion
cable (IP-cabling to XLR-male) to connect
the first unit in the line to the controller.
 Pin layout XLR-3pin: Pin1 = GND ~ Pin2
= Negative signal (-) ~ Pin3 = Positive signal (+)
 To prevent strange behavior of the light effects, due to interferences, you must use a
90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables, this
simply won't work!
 If the projector is followed by units that have a regular DMX-input with XLR-3pin,
please use the supplied DMX output
conversion cable (IP-cabling to XLR-
female) to make the connection.
 Make sure that all units are connected to
the mains.
 Each unit in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode. In the next section you will learn how to set the DMX addresses.
BRITEQ
®
5/50 LDP-COBWASH 50 + 100 (WW/CW)
OPERATION MANUAL