Hama Big Zapper Instrucciones De Uso página 13

6. Special Functions
6.1 Punch Through Channel
The Punch Through Channel allows the CH+ or CH- commands to bypass the
currently controlled device and switch the channels on a second device.All
other commands remain uninfluenced.
To activate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "CH+" key.
• Press desired device mode key (e.g. SAT).
• Release "CH+" (the indicator flashes once if the setting is activated).
To deactivate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "CH-" key.
• Press desired device mode key (e.g. SAT).
• Release "CH-" (the indicator is flashing twice if the setting is deactivated).
6.2 Punch Through Volume
The Punch Through Volume allows the VOL+ or VOL- commands to bypass the
currently controlled device and adjust the volume on a second device. All other
commands remain uninfluenced.
To activate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL+" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL+" (the indicator flashes once if the setting is activated).
To deactivate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL-" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL-" (the indicator is flashing twice if the setting is deactivated).
6.3 Macro Power
Macro Power enables you to turn two TV/STB devices on/off simultaneously.
To activate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator flashes once if the setting is activated).
To deactivate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator is flashing twice if the setting is
deactivated).
7. LEARN MODE
This remote control is equipped with a learning function. Thus, you could learn
functions of your original remote to this remote control.
7.1 BEFORE STARTING LEARN MODE
• The batteries in the two remote controls have to be in good condition.
Replace them if necessary.
• Place the remote controls with the infrared diodes so that they point
towards each other.
12
TV
CODES
SAT