Scag Power Equipment SW Serie Manual Del Operador página 21

Section 5
TROUBLESHOOTING CUTTING CONDITIONS (CONT'D)
CONDITION
SCALPING - BLADES HITTING
DIRT OR CUTTING vERY CLOSE
TO THE GROUND
Width of Deck
STEP CUT - RIDGE IN CENTER
OF CUTTING PATH
Width of Deck
SLOPE CUT - SLOPING RIDGES
ACROSS WIDTH OF CUTTING
PATH
Width of Deck
CAUSE
Low tire pressures
Ground speed too fast
Cutting too low
Rough terrain
Ground speed too fast
SGB022
Wet grass
Blades not mounted evenly
Bent blade
Internal spindle failure
Mounting of spindle incorrect
SGB024
Bent spindle mounting area
Internal spindle failure
Bent deck housing
SGB025
Check and adjust pressures
Slow speed to adjust for conditions
May need to reduce ground speed, raise
cutting height, change direction of cut,
and/or change pitch and level
May need to reduce ground speed, raise
cutting height, and/or change direction
of cut
Slow speed to adjust for conditions
Cut grass after it has dried out
Adjust pitch and level
Replace blade
See your authorized SCAG dealer
See your authorized SCAG dealer
See your authorized SCAG dealer
See your authorized SCAG dealer
See your authorized SCAG dealer
17
R
CURE