Cleaning And Maintenance; Technical Specifications - Perel EWL413 Manual Del Usuario

4. Features

handle with soft-grip foam protection

CLASS 2 design

high-performance SMD LEDs

suited for outdoor use (IP54)

power cord length: 5 m
5. Overview
Refer to the illustrations on page 2 of this manual.
1 protective glass
2 handle
6. Operation
General Use
1. Place your work light on a flat and stable surface.
2. Insert the power plug into the mains to switch it on.
3. Switch off after use by pulling the plug from the mains.
Mounting bracket
1. Slightly loosen the fixing knob.
2. Adjust the mounting bracket as desired.
3. Re-tighten the fixing knob.
7.

Cleaning and Maintenance


All screws should be tight and free of corrosion.

The housing, the visible parts, the mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the connections...

Mechanically moving parts must not show any signs of wear and tear.

If the protective glass is damaged, have it repaired immediately by a qualified technician. Do not use
the lamp with a cracked or broken protective glass.

Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

There are no user-serviceable parts.

Contact your dealer for spare parts if necessary.
8.

Technical Specifications

electrical data
total nominal power
nominal voltage driver
power factor
energy consumption
light technical data
colour
colour temperature
beam angle
luminous flux
colour rendering index
starting time
warm-up time (60 %)
V. 01 – 18/06/2015
EWL413/EWL415
3
4
EWL413
< 30 W
220-240 VAC, 50/60 Hz
30 kWh/1000 h
neutral white
2300 lm
4
bracket fixing knob
power cord
EWL415
< 50 W
> 0.9
50 kWh/1000 h
4000 K
120°
4000 lm
> 70
< 0.5 s
< 2 s
©Velleman nv