Technical Data; Before Starting The Equipment; Operation - Gardol GBLE 650 Manual De Instrucciones Original

Aspirador de hojas con motor de gasolina
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Engine type ............... 2-stroke engine; air-cooled
Engine power (max.) .................... 0.65 kW/0.9 hp
Displacement ........................................25.4 ccm
Max. engine speed ............................... 8000 rpm
Ignition: ................................................Electronic
Weight (with empty tank) ............................7.5 kg
Tank capacity ............................................800 ml
Spark plug ................................................ RCJ6Y
Maximum air speed ...............................210 km/h
Maximum delivery rate .......................... 650 m
Mulching ratio .............................................. 10:1
Debris bag volume .........................................55 l
Vibration a
.........................................21.27 m/s
hv
Sound pressure level, L
Sound power level, L
WA

5. Before starting the equipment

5.1 Assembly
Blower tube assembly (Fig. 1a)
Push the blower tube (14) into the blower housing
and secure the blower tube using the securing
screw (19). Tighten the screws (19).
Suction extension assembly (Fig. 1b)
When in suction mode, the suction extension (16)
can be assembled. For this, insert the suction ex-
tension (16) into the blow pipe (14).
Fitting the carrying strap (Fig. 2).
Attach the carrying strap clips to the eyelets on
the handle provided for them.
Fitting the debris bag (3a – 3c)
Push the debris bag (11) over the debris bag
adapter and secure it with the Velcro fastening (A)
above the ridge (B) on the suction tube. Attach
the debris bag to the lug (C) on the blower/suction
tube.
Anl_GBLE_650_SPK7.indb 22
Anl_GBLE_650_SPK7.indb 22
GBR
/h
3
2
...................... 97 dB(A)
pA
........................ 111 dB(A)
- 22 -
5.2 Fuel and oil
Recommended fuels
Use only a mixture of normal unleaded petrol and
special 2-stroke engine oil. Mix the fuel mixture as
indicated on the fuel mixing table.
Please note: Do not use a fuel mixture which has
been kept for longer than 90 days.
Please note: Do not use 2-stroke oil with a
recommended mixing ration of 100:1. If inade-
quate lubrication causes engine damage, the
manufacturer's engine warranty will be voided.
Please note: Only use containers designed and
approved for the purpose to transport and store
fuel.
Pour the correct quantities of petrol and 2-stroke
oil into the mixing bottle (see scale printed on the
bottle). Then shake the bottle well.
5.3 Fuel mixture table
Mixing procedure: 40 parts petrol to 1 part oil
Petrol
1 liter
25 ml
5 liters
125 ml

6. Operation

Please note that the statutory regulations gover-
ning noise abatement may diff er from town to
town.
6.1 Cold start (4a-4c)
Fill the tank with the required amount of oil/petrol
mix. See "Fuel and oil".
1. Place the equipment safely and securely on
the ground.
2. Set the ON/OFF switch (2) to "I" (Fig. 4a)
3. Press the throttle lever (4) until it locks (Fig.
4a)
4. Press the fuel pump (12) (Fig. 4b) 10 times.
5. Set the choke lever (13) to " ".
6. Hold the equipment fi rmly by the handle.
7. Pull the starter cable out a short way until you
feel resistance – it must be pulled evenly and
quickly to start the engine. When the engine
is running, set the choke lever to " ".
8. Allow the engine to warm up for approx. 10
seconds.
9. Press the throttle lever lock. The throttle lever
will jump back into its idling position.
2-stroke oil
18.04.13 10:19
18.04.13 10:19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

34.360.33

Tabla de contenido